home
***
CD-ROM
|
disk
|
FTP
|
other
***
search
/
Tech Arsenal 1
/
Tech Arsenal (Arsenal Computer).ISO
/
tek-20
/
mods_all.zip
/
KAM.5
< prev
next >
Wrap
Text File
|
1992-09-15
|
2KB
|
32 lines
KAM.5
The AM/FM push-button switch on a KAM panel (S2) changes not only
compression rate of the input amplifier system (U1-14, Q5 and Q6), but
signal input sensitivity. Reduction of the first is desired for a CW
reception to avoid "swamping" of the circuitry (over-compressing); however,
the second effect could create a problem in interfacing with a transceiver.
I use ICOM-751 transceiver and feed the KAM from high impedance output (10
kohm) before AF gain control and power amplifier (pin 4 of 24-pin plug).
Since the impedance of KAM audio input is only 600 ohms, the signal is much
attenuated. To develop the required 20 mVpp on the input pin for non-CW
reception (the switch in FM position), the transceiver has to output 0.35
Vpp (20*10600/600). But, if the switch is in AM position, the de-sensitized
input (about 100 mVpp) requires at lest 1.8 Vpp. This value, which is close
to distortion limit of the transceiver, I could obtain with strong signals
and with disconnected AGC (in OFF) only.
I have slightly modified the KAM circuitry by disconnecting the AM/FM switch
from ground and connecting this point to the R1-R13 junction. The switch
changes rate of compression only. The sensitivity of AF input remains
constant at 20 mVpp.
Now, I could:
- copy very weak CW signals which hardly move the S-meter,
- use large dynamic range of the transceiver automatic gain control and
- enjoy easiness and speed of tuning to a CW station.
CONTINUED IN KAM.6